Welcome to visit Chengming Driving Technology (Kunshan) Co.,Ltd ，We will serve you wholeheartedly！

Hotline
400-0763-166

News Center

Contact information

HotLine：400-0763-166

Phone：0512-57970560

FAX：0512-57970119

Suzhou：Manager He 18013250267

Wuxi：Manager Yuan 18013250256

WebSite：www.fecochina.cn

Address: No. 8, Changlou Road, Economic Development Zone, Kunshan, Jiangsu


Home >News Center　>　News Center

FECO Control requirements for transmission components of Fico hard tooth surfa...

2022-04-01

　　Loss will occur in the process of use, and this loss cannot be eliminated. However, we can try to reduce this loss, which is inseparable from the design process of its transmission components. It can not only provide more lasting driving force for the equipment, but also help to complete the deceleration work.

More

Why is the reducer housing charged?

2022-03-04

　　When the reducer cannot be started, it cannot be forced to start the motor several times, which will cause damage to the motor. An in-depth analysis should be made according to the specific conditions and symptoms, and the reducer should be started again after finding out the reason why it cannot be started, so as to avoid the expansion of electric common faults. What is the reason for the induction electrification of the re...

More

Why the Gear of Precision Planetary Reducer Fails

2022-02-22

　　1. In terms of pressure angle, the bearing capacity of small pressure angle gear is small; However, the gear with large pressure angle has a higher bearing capacity, but the bearing load increases when the transmission torque is the same, so it is only used in special cases. The tooth height of gear has been standardized, and the standard tooth height is generally adopted. Modified gear has many advantages, and has been wide...

More

Processing and maintenance of gear parts of precision planetary gear reducer

2022-02-18

　　The processing of gear parts of precision planetary gear reducer needs maintenance. First of all, the precision planetary gear reducer can only be installed on a flat, shock-absorbing and torsion resistant support structure. In any case, it is not allowed to use a hammer to drive the pulley, coupling, pinion or sprocket into the output shaft, which will damage the bearing and shaft.

More


9 3 0 1 2 3 4 5 6 7 8 9 4 : 8/9Page,Total 36 records, 4 records/page GotoPage

    • Zhengming Transmission Technology (Kunshan) Co., Ltd. All rights reserved
    • Address: No. 8, Changlou Road, Economic Development Zone, Kunshan, Jiangsu
    • Hotline：400-0763-166
    • Phone：0512-57970560　　Suzhou：Manager He 18013250267　　Wuxi：Manager Yuan 18013250256
  • 苏ICP备88888888
Mobile website