Welcome to visit Chengming Driving Technology (Kunshan) Co.,Ltd ，We will serve you wholeheartedly！

Hotline
400-0763-166

News Center

Contact information

HotLine：400-0763-166

Phone：0512-57970560

FAX：0512-57970119

Suzhou：Manager He 18013250267

Wuxi：Manager Yuan 18013250256

WebSite：www.fecochina.cn

Address: No. 8, Changlou Road, Economic Development Zone, Kunshan, Jiangsu


Home >News Center　>　Company dynamics

FECO Steps to be followed for oil change of hard tooth surface reducer

2021-06-30

　　It is dangerous to use a hard-toothed reducer, so you should understand it clearly when using it. The following is a brief understanding of the steps that should be followed for changing the oil of a hard-toothed reducer:||1. Cut off the power supply to prevent electric shock: wait until the reducer cools down and there is no danger of burning.||2. Open the oil level plug, breather and oil drain plug, and drain all the oil.|...

More

Improvement Analysis and Application of Zhengming Reducer Lubricating System

2021-06-12

　　The improvement of the lubricating system of the reducer solves the problem of high failure rate of the reducer of the horizontal rotation extractor; the safety and stability of the transmission system of the horizontal rotation extractor are improved by installing the rotor balance and limit device. The speed of the fixed-bottom flat-rotating extractor is relatively slow, and there are few rotating parts, so the relative fa...

More

Troubleshooting of gear reduction motor DC brake

2021-05-10

　　Geared Motor DC Brake Fault Symptom 1: The Brake Does Not Operate||Cause analysis and solution:||1. Unpowered power supply - power supply||2. To make the pad worn out——replace the pad with a new one||3. The gap is too large - adjust the gap||4. Insufficient power supply voltage - provide correct voltage

More

Precautions for lubricating oil replacement of the name reducer

2021-03-22

　　Everyone knows the use of the reducer, but what should be paid attention to when replacing the lubricating oil in the reducer?|| Under normal circumstances, the replacement of the lubricating oil of the reducer needs to be carried out at the operating temperature of the mechanical equipment, because the oil temperature is relatively high at this time, and the viscosity of the oil is relatively low, so the replacement i...

More


9 3 1 2 3 4 4 : 3/4Page,Total 15 records, 4 records/page GotoPage

    • Zhengming Transmission Technology (Kunshan) Co., Ltd. All rights reserved
    • Address: No. 8, Changlou Road, Economic Development Zone, Kunshan, Jiangsu
    • Hotline：400-0763-166
    • Phone：0512-57970560　　Suzhou：Manager He 18013250267　　Wuxi：Manager Yuan 18013250256
  • 苏ICP备88888888
Mobile website